User Panel
User Panel
User Panel
|
Posted: 3/20/2024 7:14:47 AM EDT
Are the bolt catch pin hole and take down detent holes threaded?
|
|
|
|
|
Posted: 3/20/2024 11:30:31 AM EDT
[#1]
No.
At least my last three were not. |
|
|
|
MN, USA
|
Posted: 3/20/2024 10:16:24 PM EDT
[#2]
were they on anyones the milspec lowers? ive been building them for years and must have missed this?
|
|
|
|
Posted: 3/20/2024 10:58:28 PM EDT
[#3]
None that I have built were threaded. The safety detent was and the spring had to be cut to fit.
Wilson and I think the last aero I built were threaded. |
|
|
|
|
Posted: 3/20/2024 11:14:28 PM EDT
[#4]
No. I just put another LT-15 together and the holes are not threaded. Standard roll-pin.
|
|
|
|
|
Posted: 3/21/2024 10:04:55 AM EDT
[#5]
Quote HistoryOriginally Posted By SpeyRod: None that I have built were threaded. The safety detent was and the spring had to be cut to fit. Wilson and I think the last aero I built were threaded. Aero threads the rear take down spring/detent hole. However, I've found that using even short set screws can cause the spring to be compressed too much and it makes moving the rear takedown pin a PITA. So, I normally trim 2-3 coils off those springs to make up for the set screw. |
|
|
|
AR15.COM is the world's largest firearm community and is a gathering place for firearm enthusiasts of all types.
From hunters and military members, to competition shooters and general firearm enthusiasts, we welcome anyone who values and respects the way of the firearm.
Subscribe to our monthly Newsletter to receive firearm news, product discounts from your favorite Industry Partners, and more.
Copyright © 1996-2024 AR15.COM LLC. All Rights Reserved.
Any use of this content without express written consent is prohibited.
AR15.Com reserves the right to overwrite or replace any affiliate, commercial, or monetizable links, posted by users, with our own.
