Archived Posts » 59,699,509
MAK 90 trigger group reassembly
1/30/2010 2:37:07 AM
Im having a helluva time getting this dam thing back together. I've got it all with the exception of the sheppards crook that is hooked around the safety lever. For some reason I cannot get the wire under the trigger cross pin. Is there a diagram that shows this procedure for a mak 90 ? I'm obviously not holding my mouth right
1/30/2010 5:11:36 AM
If at first you don't succeed...
Yes I'm tagging for the info.
Yes I'm tagging for the info.
1/30/2010 7:56:32 PM
I guess even someone could tell me if its supposed to go under both trigger and hammer pins or above one and under another would help...
1/30/2010 10:29:49 PM
Originally Posted By abadrs:
I guess even someone could tell me if its supposed to go under both trigger and hammer pins or above one and under another would help...
I guess even someone could tell me if its supposed to go under both trigger and hammer pins or above one and under another would help...
it goes under hammer, over trigger then the bend goes up to the safety. prolly have to slide the hammer pin back out a bit to get the small ring under and in front of the pin. then stand the wire up in position. you will need to then press it down to the floor of the receiver to get the hammer pin back into position. then it's smooth sailing from there.
1/31/2010 4:44:19 AM
Well I guessed right...I had it under the trigger...man that was a bitch getting that apart...I've been messing with AR's way to long ...lol
Where in Ohio Mays ? Canton here
Where in Ohio Mays ? Canton here
1/31/2010 11:26:04 AM
S.E , athens area
2/2/2010 10:21:36 AM
for future reference:
2/2/2010 8:37:57 PM
nice chart. i think both of my romy's came from the shop installed wrong. i guess it doesn't matter since i replace everything with the "L" style anyway. good to know for the future though, thanks.
