These have regained their popularity. Sources for 13 round original magazines have long dried up.

Daewoo?

S&W 59 series mags supposed to work

The magi’s based on the S&W 69/59 series and are interchangeable.

To answer everyone the S&W model 59 magazines work but the fact that they extend about a half inch below the flush fit makes them in my opinion not suitable for carry. I almost think it might be worth making or adapting a spacer that would keep it from getting caught or catching on anything when pulling. Has anyone ever made a magazine spacer that would slip over a S&W 59 ?

Precision Gun Specialty has a slip over mag adapter to adapt a 59 series mag to the shorter grip  469/6904 series pistols.  The PGS mag adapter is listed as a Plus 2 adapter for using a Model 459 mag in a model 469/6904.   My Agencies issued some 6904 pistols where the pistol was supplied with the shorter 12 round mag with finger extension and a 14 round mag with the PGS adapter.  S&W later changed to an orange follower permitting 15 round in a 59/459/5904 mag.


You can order the PGS adapter directly from their web site.   There is an order form with the information on the web site.   I think this adapter could be made to fit the Daewoo pistols.

http://www.precisiongun.com


I’m not sure if X Grip makes one but it wouldn’t be difficult to get one 3D printed.   I checked and X Grip only sell adapters for the polymer M&P pistols.

Here are pictures of the Precision Gun Specialty mag adapter package and how it looks in a 6904 pistol.

I think you are right. Thanks for the tip I'll reach out and give it a try. If it works I will follow up on here

I ordered two and hope that they can be made to work.

I hope you can make them work.   Let us know how it turns out.

Well I ordered two and went to work. 6 hours later I had one that would work and destroyed one. Clamping them in my mill vise proved to be challenging. They end up pretty thin when it would lock in. Long story short I'm going to try some different material and change the design some after hunting season is over

Thanks for the update, sorry it wasn’t 100% success.   I bet someone good with a 3D printer could turn them out pretty quick.   To bad my Son doesn’t have a 3D printer now since he changed jobs.   He’d made them for free just for the fun.