Been a fan of the PA prism scopes since they came out. 2 weekends ago took a son and grandson shooting. I wanted to try out my 8" Bren 2 with the SLX 3x scope.
I just did not seem to get on paper no matter what I did so shelved the gun and shot something else.
Today I went to an indoor range with reactive targets to try the 8" Bren2 and its 11.5" cousin. I was not sure where the issue was so wanted to also check barrel lengths for possible issues.
8" - shot it to get irons on target at 40'. Switched to the SLX and started back at 20'. Well to the left. Adjusted to the right and very little help. Had it all the way to the right and I could not hit center unless I did a hold over to the edge of the black circle.
Same with the 11.5".
So it seems it is either my adjustment wheel is reverse marked (I tried dialing it back to the left and I was going off paper, the mount is not square (it was tight), the optic/mount is off or I suck at shooting.
Anyone have any issues with theirs?
Attached File Attached FileWell I had an ADM mount that fit this. Went to the range using 2 other rifles. No help - still cannot get it to center. Contacting PA about a swap.