Rudy,
I picked up a 16" D/I upper back when I was down in NJ, which I'm looking to SBR the lower it is attached to (switched out the fixed stock when I got up here, and running your magazines in it). Just wanted to see if that is something I can have you do.
Was looking to put the barrel just past the end of the forend, which I'll probably measure tonight when I get home to figure out (want to say like 11" to 12" range, if I remember correctly the last time I looked it over), and then thread it to .578x28... as I'll likely get a suppressor in the upcoming year or so. Any issues going shorter with a barrel like that?
Also, reading the SBR regulations for engraving, would it be possible to have you also stamp ".45 ACP" on the barrel so that I can just do the name and location on my lower? Wanted to SBR that lower, as it is still a standard pattern lower... so can swap uppers if desired (after notifying ATF).
Thanks for your time. Hope all is well down there.