Problem: I bought a single spectrum I^2 laser for a personal gun and didn't have the means to get a rough zero on my laser at night for a few weeks.
Solution: I have a 3D printer, and made a plastic mount to put my PVS14 behind my red dot temporarily so I could get my laser close.
I've been using this on a few different guns for the last few months and it works very well to get your laser roughly zeroed. I've also made one that can attach to scope eyepieces as well. That one is in the works. These are obviously NOT made for shooting, just aligning your laser to your red dot.
Either way, I figured I would offer it up if people were interested in one. They would be pretty cheap at roughly $10 shipped to your door. I can do absolute cowitness or lower third like pictured. They will obviously wear out eventually going on and off a bunch, but they are pretty cheap.
Thoughts? Feedback? Interest?