My first. Started back in September. I originally had a Mako GLR16 stock on a Vltor buffer tube with a Troy OEM endplate and a Diamondhead VRS-T 10.25 handguard. I shot it a couple times and decided to switch to the Magpul UBR and Centurion CMR 14. I switched the stock because I like the constant cheek weld of the UBR and switched the rail to get a bit more length and to lighten up the front. The UBR is quite a bit heavier than the stock/tube setup, almost a pound. Over all I added 10 oz with the switch, but it is very balanced and weighs 8.2 pounds loaded with the red dot and LT-FUG on. Originally, I was searching for cover-all optic solution. I decided go with two QD setups instead. Red dot for close stuff, scope for longer. If I every get a 7mm, 308, or whatever, the scope will move to that. Very happy with the over all product. I have handguard covers to add on, but I'm waiting to work out the mounting hole offset issue with Centurion.
First couple pix are the original setup from the phone, the rest my brother took with some better equipment with the rifle in its different configurations.
Build list:
Lower
Lower Parts Kit: CMMG
Lower Receiver: MEGA
BCG Trigger & Hammer: TR Enabling
Safety: BAD-ASS w/ Crank and Short-Thin
Pivot/Takedown Pins: Battle Arms Development Enhanced
Grip: Command Arms 6 piece
Stock: Magpul UBR
Buffer Spring: David Tubbs Flat-wire
Buffer: Spikes Tactical ST-T2
Trigger Guard: Magpul enhanced
Mag Release: Troy Ambidextrous release
Upper
Upper Receiver: MEGA
Rail: Centurion CMR 14”
Rail Accessory Pack
Barrel: Wilson Combat 16" SS fluted
Gas Block: Troy Low Profile (shaved to fit rail)
Charging Handle: Rainier Arms Raptor
Back-up Sights: Magpul MBUS
Muzzle Break: Rainier XTC
Optics
Scope: SWFA SS 12X42
Scope Mount: Larue LT104
Red dot: Vortex Sparc
Red dot mount: Larue LT751
Accessories
Bipod: Harris LM
Bipod Mount: Larue LT130
Light: Streamlight TLR-1 HL
QD rings: Damage Industries D ring
Sling: Magpul MS3
Foregrip: Larue LT-FUG