AR Sponsor
Joined:
Sep 2023
Posts:
735
EE: 92% (13)
PA, USA
Posted: 6/9/2025 11:17:59 AM EDT
| Just picked up a blem H&R 635 upper and it's great however the dust cover won't remain closed on a closed or open bolt. It flops open as mag is inserted, the detent protrudes as it should and works fine without a mag inserted. On an odd number of rounds in magazine is doesn't retain hardly at all, never had this issue with any Ar centerfire or pcc. Out of spec? |
|
I had this problem before, and the spring on the dust cover was installed incorrectly. Mine was a 556 upper. Grab another upper that works properly and closely compare the install of the spring. Attached File |
Joined:
Sep 2023
Posts:
738
EE: 92% (13)
PA, USA
|
Originally Posted By livinfree: I had this problem before, and the spring on the dust cover was installed incorrectly. Mine was a 556 upper. Grab another upper that works properly and closely compare the install of the spring. https://www.ar15.com/media/mediaFiles/273029/IMG_2487_jpeg-3560216.JPG I'll take a look thank you. |
|
Originally Posted By cjcutter: Just picked up a blem H&R 635 upper and it's great however the dust cover won't remain closed on a closed or open bolt. It flops open as mag is inserted, the detent protrudes as it should and works fine without a mag inserted. On an odd number of rounds in magazine is doesn't retain hardly at all, never had this issue with any Ar centerfire or pcc. Out of spec? @Mike_NDS |
Palmetto State Armory
3760 Fernandina Rd
Columbia, SC 29210
Web Sales: 1-803-724-6950
3760 Fernandina Rd
Columbia, SC 29210
Web Sales: 1-803-724-6950
Joined:
Sep 2023
Posts:
745
EE: 92% (13)
PA, USA
Joined:
Sep 2023
Posts:
764
EE: 92% (13)
PA, USA
|
Originally Posted By mike_nds: If you find you need to send it back, pm me with your order number and I’ll get you a shipping label It was returned to @PalmettoStateArmory yesterday @mike_nds. I truly believe it's the bcg I tried a different bcg and it ran as expected. Different lower and original bcg the issue still remained with a closed bolt and an even number of rounds in the magazine the dustcover won't stay closed and a couple failure to feed using metalform/colt mags out of approximately 200rnds of factory 115 fmj. |
|
Originally Posted By cjcutter: Just picked up a blem H&R 635 upper and it's great however the dust cover won't remain closed on a closed or open bolt. It flops open as mag is inserted, the detent protrudes as it should and works fine without a mag inserted. On an odd number of rounds in magazine is doesn't retain hardly at all, never had this issue with any Ar centerfire or pcc. Out of spec? Yes its our of spec. The assembly that holds the detent sits too far forward and isn't held in that well. I just cut down a spare full length dustcover and it works much better |
AR Sponsor