Hello all.  I had an incident with some ammo that exploded when the rifle was fired.  The magazine was fine for the most part, however, the follower was broken.  I believe that they still use a proprietary follower, but am not entirely sure

The questions is, does anyone know of a magazine follower that will fit in the Lancer 30 rd 5.56 mags?  Either replacement part or, if possible, 3D print STL?

Thank you in advance

P.S.  Sorry if there is a thread about this, most of the ones I found were simply discussions about modifying P-Mag followers or the like

Did you ask Lancer?


There’s an aftermarket “big bore” follower I know of

https://www.bigboremag.com/product/ar-15-big-bore-follower-for-lancer-magazine/

I have seen that one, trying to get some dimensions on it.  And I sent an email to Lancer, I will give it a couple days and reach out again.

Thanks : )