AR Sponsor
Posted: 2/18/2026 9:21:10 AM EDT
[Last Edit: vinnie935][Edited]
|
Looking for some advice on installing the pre drilled low profile gas block on a Daniel Defense barrel. I’m positive that I put the taper pin in correctly and then, using a cupped nail set, attempted to drive it in. This is as far as it would go. Is this pin installed far enough?Attached File |
|
Originally Posted By TGWLDR: I wouldn't sweat it personally. If you absolutely can't live with it, Amazon sells taper reamers for relatively low prices. Thanks for the reply. I’m not really worried about the aesthetics, I just want to be sure it’s not going to back out. Do you think it’s OK? |
|
Originally Posted By TGWLDR: I wouldn't give it a second thought. Run it. OK, I’ll go with it. This is the first time I’ve installed a low profile gas block, much less one with a taper pin. Just needed a bit of validation. Thanks for the advice, I really appreciate it. |
AR Sponsor