Armory Sponsor
Posted: 10/17/2023 11:24:05 PM EDT
|
I bought a couple RPD kits in 2011 along with some 80% receivers, but the barrel hole is solid. Anyone have a drawing of a proper lower so that I can unfuck my first attempt? 
|
Critical thinking is dead.
|
Originally Posted By Third_Rail: I don't have a drawing handy but I'll have a receiver with the barrel pressed out of it in the next month once I get to it. What measurements exactly do you need? |
Critical thinking is dead.
|
@Cole2534 To the centerline of the barrel bore: 1.023" from the tall side of the receiver bottom .776" from the short side of the receiver bottom .523" from the bottom of the action shelf This particular receiver is a semiauto DSA and the barrel bore is .930". Picture to follow. ETA: Simple picture just so it's clear what I meant about the tall and short sides. 
|
|
Originally Posted By Third_Rail: @Cole2534 To the centerline of the barrel bore: 1.023" from the tall side of the receiver bottom .776" from the short side of the receiver bottom .523" from the bottom of the action shelf This particular receiver is a semiauto DSA and the barrel bore is .930". Picture to follow. ETA: Simple picture just so it's clear what I meant about the tall and short sides. https://i.imgur.com/MAvokDr.jpg |
Critical thinking is dead.
Armory Sponsor