I have a p10c that I have no practical use for.  I carry it sometimes as an off duty gun, but for on duty I much prefer my da/as sigs.

I'm thinking it would be good to put it in a roni.

Thoughts?

You mean to go with your other Micro Roni so you can dual wield?!?

YES!!!

I meant intelligent thoughts.

It was on sale. I ordered it in tan to match my fde cz.

Yrsinc

The only glock product I own is their holster. It is probably the single best product they make and fits the CZ perfectly.

I do not care for their pistols. I've had three, and all went down the road without regret. Thankfully they were all blue label so I didn't lose money on them.

The CZ I like and is worth the extra mag cost.

It shows processed through Tel Aviv on the 9th. Hope its here soon.

It is here. P10c fits perfectly with none of the wiggle I've seen from glocks.

I don't know if this is because the gen 4 tightened up tolerance or CZ uses a stiffer polymer or both.

I put A see all sight on it for now to try it out. Not sure if I'll like the sight, but wanted to try something without batteries.

So, I have about 500 trouble free rounds through the base pistol without the Roni.  On two separate shooting sessions, with the Roni, The gun locked up, round not completely chambering but stuck just short of battery at around 5 mags through.  I expected the pistol to be filthy on the exterior as per factory demos and advice.

I did not expect that the fouling would make it's way to the chamber. This appears to be what's happening and at about the 75 round mark, enough fowling has built up to prevent a round from going into battery.  In each case, removing the pistol, clearing the chamber and a quick brushing was sufficient to restore function. The ammo is my reloads, PC cast lead over Unique.  I know this is a dirty round, but never a problem in this pistol, or my Sigs.  The issue seems to be the Roni trapping gases that are coming back into the chamber.  Ideas?

Now the good.  Accuracy is certainly better out to 50 yards than just the pistol.  Inside 20 yards, my naked pistol groups are similar, but certainly not as fast. Out to 30 yards I'm pretty much stacking rounds on top of each other with the Roni, one ragged hole. Also, in each case of malfunction and required cleaning, it is happening beyond the point where I would have exhausted my carry load out.  So while not ideal, not really a detriment either.

My only current solution is to take a bore snake to the range and do a pull through every 4 mags.  Any other ideas.

I like that idea.

I am curious to know what modifications to the chasis were required?

I think I'll just pull through a bore snake every three mags or so.