Shoot Shoot Shoot, Bullet Bullet Gun.......
Joined:
Jun 2009
Posts:
1302
EE: 100% (53)
TX, USA
Posted: 6/11/2024 9:25:44 PM EDT
Looking at sending in some URGI parts for a pin & weld but as shown in the below photo, over half the threads are damaged (flattened). I would like to use a suppressor in the future so want to make sure the mount is "straight"? I know I need the Surefire muzzle device pinning service, but what should I select service wise for checking/fixing the threads? The standard barrel threading service? |
|
Originally Posted By bigbore: If you are going to mount a suppressor, the only way to do that right is chop all the existing threads of and re thread the shortened barrel. This, but if you don't have enough length to get to 16 after that i would test mount the device and can and check alignment before pinning. |
Shoot Shoot Shoot, Bullet Bullet Gun.......
Joined:
Jun 2009
Posts:
1303
EE: 100% (53)
TX, USA