AK Sponsor
Posted: 11/25/2013 6:13:48 PM EDT
| So I just installed an Ace Receiver Block, Ace Side Folding Adapter and Ace Skeleton Stock on my Yugo M70 O-PAP and I have a question for anyone who has done this before. When I was installing the receiver end block, the screw they provided would get almost all the way tight and then it was like it hit a brick wall. I checked the threads on both the receiver and the bolt and they both were fine. I was able to put alot of force on it and finally get it to tighten up enough to keep the plate tight but it just seemed a little odd to me. Has anyone else ran into this before with the Ace Receiver block? And also the screw doesnt even go all the way through the threads on the receiver. It stops with about 2 or 3 threads still left. Any input on this is greatly appreciated. |
|
Quoted:
Mine went all the way in. Are you using a washer? If not that should work, if you are using one maybe try a thicker one. My 2¢ Well I tried using the washer that was on the original stock bolt at first but it wouldnt let the bolt go in far enough to clear the slot where the folding adapter went into. Maybe I need one thats a tad thinner than that one. But even without a washer the bolt doesnt do all the way through the threads on the receiver. Maybe I need to get a longer bolt. |
|
Quoted:
I had the same thing with my M77. Once I tightened it down it never happened again. This happened to me aswell man on my m70 pap... I just gave it the beans man... Nothing stripped, it seated all the way and I never had an issue with it. I asked the same thing on here when I put the ace receiver plate on mine and some members chimmed in saying they had the same experience, you should be good 2 go man. |
|
Quoted:
This happened to me aswell man on my m70 pap... I just gave it the beans man... Nothing stripped, it seated all the way and I never had an issue with it. I asked the same thing on here when I put the ace receiver plate on mine and some members chimmed in saying they had the same experience, you should be good 2 go man. Quoted:
Quoted:
I had the same thing with my M77. Once I tightened it down it never happened again. This happened to me aswell man on my m70 pap... I just gave it the beans man... Nothing stripped, it seated all the way and I never had an issue with it. I asked the same thing on here when I put the ace receiver plate on mine and some members chimmed in saying they had the same experience, you should be good 2 go man. Awesome, thanks for letting me know guys. I was hoping that it wasnt just me experiencing this. |
AK Sponsor