AK Sponsor
Posted: 12/5/2004 12:35:09 PM EDT
Hello G2 trigger. I just finished instaling my G2 trigger. It finally came off of backorder. No more trigger slap for me. It was a pretty easy job thanks to linx310 page being that it didnt come with any instructions. Now if my threading kit and slant brake would finnally arrive I can finish fixing up my SAR-1. The trigger feels pretty good when dry fired compared to the old one. Cant wait to actually fire the freakin thing.
|
compared to that crappy trigger of Century....
I got a fairly nice two-stage out of my Century trigger. Good enough I haven't spent the money for anything else.  And don't ask me how I did it. I don't know. I just trimmed the tail off the whatever piece and stoned the heck out of the contact surfaces. Although I may spend some time this winter with the stones again. Push it to the limits!!! Maybe I'll learn something. Like when to stop when I'm ahead. 
|
not hard at all, just make sure to get that retaining wire out first and then just punch out the axis pins and it will come right out. Just make sure to keep an eye on the disconnector spring. |
| Longhorn: It was quite easy with his instructions. It took me about 20 minutes. Could probably do one in about half the time now. The shepard hook sucks but not too bad. There is an alternate way to reininstall it that is not as hard as the way it came out. Anybody with basic tools and half of their braincells could do it. The g2 kit came with a sleeve to hold the trigger and disconector toghether until the pin is slid through so you dont lose that little spring. |
+1 G2, about 20-25mins wrestling with the shepherds hook. Otherwise, it was pie. No fitting required. I'm rebuilding a bunghole, singlestack WASR-10. It had the original rommie FCG which wasn't too bad really. Gritty, but around 5lbs. and no slap. The G2 is a vast improvement though.
|
|
New guy to the AK (Dark Side) forum along with my WASR10. I just completed my replacement of that piece-of-shit trigger system by Century Arms. I can't believe that are laws allow such garbage. Anyhow, I installed the Red Star Arms trigger system and all I can say is WOW. I must acknowledge and give a BIG  to Linx310 for his site which was absolutely a no brainer (especially for someone that has never handled an AK until now.)I'll post pic of WASR10 after I do some minor tweekin' До Следующего раза |
Not only allowed.. Required! They're especially bad when you consider that the Romanians, never ones to stress over such things as final finish, made a better trigger group than whatever drunk orangutans fashioned the CAI trash. |
| Why do you guys replace the FCG? just modify the Century one. Compare the C with the G2 and you will not see much difference except for the extra metal. Just use the G2 as a pattern and grind/remove the difference then heat treat the hook on the hammer and you are good to go. Just try it ,you got nothing to lose with the Century set just sitting around. This is only my opinion but I think the G2 and C are made by the same company,the G2 just does a few more machining steps. |
I personally like the feel of the actuall G2 trigger more. No, century makes the C FCG and tacpo makes the G2 |
www.gunsnet.net/Linx310/fcgremoval.htm |
AK Sponsor