AK Sponsor
Posted: 5/27/2012 11:43:29 AM EDT
| I'm trying to remove my thumbhole stock off my Intrac akm. I removed the screw from the tang and the screw from under the cover. I pryed the end of the insert with a screwdriver through the round hole in the receiver . It comes out part of the way, but then stops. Is there something else I'm missing that holds these on. Thanks for any help or suggestions. |
|
Originally Posted By Dferg10:
Those are the only 2 screws. Try a rubber mallet and hit the back of the stock on the top and bottom corner at an angle away from the receiver, alternating between top and bottom- not too hard but solid. It will come out after awhile. There is also a 3rd screw that goes thru the original "pistol grip" square hole. It is smaller and has a large flat washer under it. |
|
Originally Posted By TUBBY:
Originally Posted By Dferg10:
Those are the only 2 screws. Try a rubber mallet and hit the back of the stock on the top and bottom corner at an angle away from the receiver, alternating between top and bottom- not too hard but solid. It will come out after awhile. There is also a 3rd screw that goes thru the original "pistol grip" square hole. It is smaller and has a large flat washer under it. I see there is. I was looking at the regular wood stock that I keep in the same box. |
|
Originally Posted By TUBBY:
Originally Posted By Dferg10:
Those are the only 2 screws. Try a rubber mallet and hit the back of the stock on the top and bottom corner at an angle away from the receiver, alternating between top and bottom- not too hard but solid. It will come out after awhile. There is also a 3rd screw that goes thru the original "pistol grip" square hole. It is smaller and has a large flat washer under it. Mine did have the 3rd screw with the washer. It did not have any slot for a screw diver , almost like a rounded head rivot, I could not find a way to loosen it. The couple of whacks with the rubber mallet pulled it loose with minimal damage. |
AK Sponsor