AK Sponsor
Posted: 3/12/2008 8:32:14 PM EDT
|
I just finished riveting up my first receiver. It turned out very nice, if I do say so myself. I built it on a NDS-3. From the NDS web site it says they don't recommend a single hook trigger for the NDS-3. What modifications do I need to make to use a double hook? Is there a tutorial anywhere? Any help is appreciated. Thanks |
|
I don't have the linkage available but the short and sweet is you need to cut a 2nd slot in the trigger area. The NDS-3 is set-up for use with the Century trigger. When using the single hook G2, the hook cutout in the receiver is too long and causes the trigger to overtravel. When cutting the 2nd slot, it needs to be cut shorter (4.5mm if I remember correctly) to stop trigger travel. Flip your receiver over and look at the area where the trigger pops through. You will see a single slot sticking out from the trigger cutout. The second slot is to be cut on the other side. It can be done with a file set on edge or dremel tool. take your time and measure often. mfn |
|
You may also experience some hammer follow. I did. Gunplumber's website will help you out with the issue. www.arizonaresponsesystems.com/notes/aktrigger/pageaktrigger.htm |
AK Sponsor