AK Sponsor
Posted: 8/22/2007 8:47:01 AM EDT
| whats up every one I just got a wsar rifle when I took it a part to clean it I found out the bolt had been switched out and it dosent match. The rifle is used the previous owner said it works fine but I dont trust it my question is will a go gauge be fine to check the head space or do you have to use a go and a no go gauge. Thank you for any info. |
| I'm a bit confused about headspace gauging also. There is some good information at the Brownells site, www.brownells.com/aspx/NS/GunTech/newsletterarchive.aspx, and I imagine elsewhere also. |
|
The only gauge you need is a no go gauge. I would get one from here www.mansonreamers.com/ If if locks up with under 25 pounds of force you need you have a problem. |
|
Thanks for the link Lazyshooter. I did not know that Brownells had technical articles. these are informative about headspacing www.brownells.com/aspx/NS/General/DisplayPDF.aspx?f=bt002025.pdf www.brownells.com/aspx/NS/General/DisplayPDF.aspx?f=bt002024.pdf |
AK Sponsor