[ARCHIVED THREAD] - looking for a part

Posted: 7/3/2007 6:48:02 PM EDT

there was a thread on here dealing with using a length of allthread to press a barrel in.

the guy had a special plate he made to fit against the trunnion, looked kinda like this

http://www.mercenariesguild.net/papercut/AK%20part.JPG

anybody know the thread im talking about or know the measurements for that plate?

Posted: 7/4/2007 5:02:03 AM EDT

[#1]

I just used a few washers and the bolt carrier.

Posted: 7/4/2007 2:14:32 PM EDT

[#2]

Quoted:
I just used a few washers and the bolt carrier.

Posted: 7/4/2007 2:30:14 PM EDT

[#3]

pretty sure that was tapeo's post, but I thought it was on another site...Just use washers instead.

Posted: 7/4/2007 4:59:41 PM EDT

[#4]

Yep, it was me.

Shoot me an email and I'll send you the measurements of it. Don't have time to do it now but in the next day or so I'll measure it for you.

Posted: 7/4/2007 5:31:46 PM EDT

[#5]

Tapeo1,

Can you post the measurements here?

Posted: 7/7/2007 9:54:32 PM EDT

[#6]

Ok, here's a pic with some measurements. The measurements are approximate. When I made this, I just started off with a 1" x 1" piece of metal that's about 0.20" thick and just cut a little here and there until it fit inside the receiver behind the bolt carrier. As was mentioned earlier, a stack of washers would probably work too. They would need to be notched at the top to fit around the little tang that sticks out the back of the bolt carrier though.

Posted: 7/8/2007 9:14:18 PM EDT

[#7]

thanks for the measurements, it helps alot.

[ARCHIVED THREAD] - looking for a part

AK Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - looking for a part

[ARCHIVED THREAD] - looking for a part