AR Sponsor
Posted: 9/29/2010 6:58:14 PM EDT
|
************Cross-posted under AR-15 Variants, thread AR Big Bore and the reloading section********************
I am using a Dillon 550 and have a Redding 2 die set # 80444. I am developing a load using a Barnes 300grn TTSX bullet and am TRYING to seat the bullet for a COAL of 2.240-2.245 Heres the problem, my seating stem is ran all the way down and the thumb lockring won't engage (lockring free-spins because the seating stem threads are below where the lockring sits and can't engage the seating stem threads). It's like the seating plug is not long enough. I might have a die problem. TBD, will start the phone calls tomorrow to Dillon and Redding. also looking for load data on IMR-4198, H110 and the 300grn TTSX, Starline Brass, WLP. Thanks |
|
Quoted:
Called Redding and they are going to send out another seating stem with the number 36 stamped on it. The seating stem I have is currently stamped with a 5. Just in case anyone else runs into this........ You can see my post here for pics: Seating Stem |
AR Sponsor