AR Sponsor
Posted: 5/27/2014 5:35:47 PM EDT
| I have found one source that said some early 607 were built on 601 slick side lowers any one else ran across that? I have a spare 601 lower I would SBR and use on my 607 build rather than waiting to get another XM16E1 lower. |
|
Quoted:
TBR pg 177 The "prototype" 607 was made from a 601 lower, triangle charging handle, duckbill flashhider, and cut down A1 handguards that use the rear half, instead of the front. Which I actually like better in practice. This surprised me because I have relatively small hands, but I like them better truthfully. |
|
Quoted:
Which I actually like better in practice. This surprised me because I have relatively small hands, but I like them better truthfully. Quoted:
Quoted:
TBR pg 177 The "prototype" 607 was made from a 601 lower, triangle charging handle, duckbill flashhider, and cut down A1 handguards that use the rear half, instead of the front. Which I actually like better in practice. This surprised me because I have relatively small hands, but I like them better truthfully. Also if you haven't noticed after sustained fire the extra air gap is very welcome. |
|
Quoted:
I know someone who is up to the task.  Quoted:
Quoted:
Does anyone make triangular caps that would fit on the large half cut-down? I have a couple samples the right size I would be happy to share as models as long as I get them back. 
|
|
Quoted:
I have a couple samples the right size I would be happy to share as models as long as I get them back. Quoted:
Quoted:
Quoted:
Does anyone make triangular caps that would fit on the large half cut-down? I have a couple samples the right size I would be happy to share as models as long as I get them back. I'm at the beginning of a move but I may want to build it later in summer. |
AR Sponsor