[ARCHIVED THREAD] - 80% build question

Posted: 4/4/2007 12:45:41 PM EDT

Does the 1/2" hole under the buffer tube hole on the lower receiver have to be cut with an end mill so it has a flat bottom? Or can it just be drilled with a 1/2" drill? It looks like it is the wall of the hole that is used to keep the stock from rotating not the bottom of the hole.

Thanks

Posted: 4/4/2007 2:06:57 PM EDT

[#1]

that hole can be drilled with a regular bit. you are correct in that it is the sides that contain the stock alignment pin. it will need to be drilled a minimum of .200" deep.

Posted: 4/4/2007 2:15:08 PM EDT

[#2]

Thank you very much JohnQ.

[ARCHIVED THREAD] - 80% build question

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - 80% build question

[ARCHIVED THREAD] - 80% build question