Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
AR Sponsor
10/17/2003 8:19:57 AM EDT
I recently purchased a TA-31A and #19S mount.  Eventually, I want to add a #40 BUIS and a RAS-II to the mix, but wondered if everything would fit.  Can you mount the TA-31A/#19S and #40 with the RAS-II mounted?

Thanks!
10/17/2003 9:00:58 AM EDT
[#1]
Should work perfectly.
10/17/2003 9:34:11 AM EDT
[#2]
Yes, you'll use up the entire top receiver rail but you can do that combo.
10/18/2003 2:37:41 AM EDT
[#3]
Quoted:
TA-31A/#19S and #40 with the RAS-II mounted?

View Quote


Splendid, truly splendid!
10/25/2003 3:36:15 PM EDT
[#4]
Thanks!
10/25/2003 11:35:24 PM EDT
[#5]
can anybody tell me how hard or easy to install a RAS II on a RRA upper with the pressed-on break?
10/25/2003 11:42:29 PM EDT
[#6]
If you can take off your standard handguards and use a screwdriver, you're g2g.
10/26/2003 10:11:07 AM EDT
[#7]
Excellent solid setup, and you have two positions for where to mount the 19S.
10/26/2003 10:39:23 AM EDT
[#8]
Quoted:
Excellent solid setup, and you have two positions for where to mount the 19S.
View Quote

is the rail on the rear part of the RASII long enough to accomodate the 19S?  [img]http://www.eaglefirearms.net/images/KAC%20images/KACRASIIFF.jpg[/img]I plan to do this same setup, but with a compact ACOG more then likely. I was warned about the ACOG not being mounted high enough on the standard flat top so if the 19S will mount on the RASII rail it would be all good.
10/26/2003 11:07:07 AM EDT
[#9]
I don't think you want to mount the ACOG/19S on the RAS II rail/hump since you're not going to be able to use the eye relief.
10/26/2003 2:51:34 PM EDT
[#10]
Quoted:
If you can take off your standard handguards and use a screwdriver, you're g2g.
View Quote


do I have to remove the barrel from the receiver?
10/26/2003 3:05:44 PM EDT
[#11]
no, it has a top and a bottom portion.  No need to remove anything other than the plastic handguards.
AR Sponsor