AR Sponsor
Posted: 2/1/2006 7:49:09 PM EDT
|
As a follow up to one of my other questions do people have opinions on a good chambering for a AR-10 I am building? I was looking at Noveskes 7.62 Noveske Match Mod 1 or a Krieger with a .308 Spec Chamber. Opinions? Thoughts? -C4- |
|
If you have a specific type of ammo in mind, then have the chamber/throat cut for it. In regards to barrels, When it's an all out tack driver, I will run with Rocky Moutian Barrels if the lead time is not long, or if I need a barrel faster, will run with a Kreiger. Both of theses are Broach cut and hand lapped. Bottom line is to find a smith some what local, and who will stand behind his custom barrels in case there is a problem with it not printing. Note: Rocky Moutian barrel Works is local for me, and Mark can have lead times of over a years, so be forewarned if you decide to have him make a barrel for you. |
Do you have contact info for Rocky Mountain Barrels? -C4- |
Would 243, 260, 7-08, 338 federal work with the original bolt? -C4- |
AR Sponsor