AR Sponsor
Posted: 9/27/2004 12:39:34 PM EDT
| I'm sure that this has been asked already and I apologize if it has. The one search per minute feature makes searching a little difficult. I have a RRA "post-ban" with a 16" barrel. The fake muzzle break isn't extended beyond the barrel. Is this fake muzzle break pressed on or threaded and pined? And what does it take to remove it. I would like to remove the fake muzzle break and install an actual flash suppersor now that the AWB is no longer existent. I went to a local gunsmith and he was talking about removing the handguards, gas tube, front site,... cutting the barrel and threading it. He estimated the cost to be about $125 for the labor plus the cost of the flash suppressor. Seemed a little excessive to me. I was under the impression the RRA is pressed on,.. tap it off and thread the barrel. Any insight is greatly appreciated. -Kevin |
|
Post this question at this link and they will answer all your questions: jobrelatedstuff.com/forums/forum.html?b=2&f=130 |
|
www.ar15.com/forums/topic.html?b=8&f=24&t=184758 Send it to LRT, I know the man and I'm 99% sure that it'll be less than 1/2 the price you were quoted shipped. Have it cut to 14.5" and rethreaded when you get it back have a Vortex or Phantom permanetly attached. |
AR Sponsor