What kind of co-witness do you get with this mount?
Posted: 12/30/2009 9:44:53 AM EDT
[#1]
What are you putting in it? This mount typically holds a magnified rifle scope where you likely won't see the front sight and the rear will probably be down, if it's installed at all.
Posted: 12/30/2009 10:23:39 AM EDT
[#2]
Also, from what I understand, you're not supposed to co-witness iron sights through a magnified optic anyway.
Posted: 12/30/2009 10:43:05 AM EDT
[#3]
It would be going on a flat top AR. Aimpoint 9000sc is what it would be holding so no magnification.
Posted: 12/30/2009 11:24:04 AM EDT
[#4]
On Burris' website they show this diagram
A - 1"
So the centerline would be 1.59" above the rail (which I believe is 2.8" over the bore center) so I'm thinking it will be lower 1/3.
Posted: 12/30/2009 3:34:50 PM EDT
[#5]
Thank you very much. Lower third is exactly what I was looking for.
Posted: 1/24/2010 6:40:45 AM EDT
[#6]
smokenruger, what did you ever come up with for mounting the 9000SC? Were you able to get the lower 1/3 co-witness?
