AR Sponsor
Posted: 9/29/2007 12:04:08 PM EDT
|
Who makes this carry handle. I was told it was pulled off a bushy... square forge?  
|
just trying to get some confirmation that its not a cheap knock off. I bought it from a new forum member who hasnt posted, and i thought i would make sure im not getting fed a line before i give him good feedback on the forum. |
where did you get the upper from? |
| Not a lot but check this www.ar15.com/forums/topic.html?b=3&f=118&t=343377 |
+1` One thing you can watch out for is how far around the elevation wheel goes. On a properly constucted top, it should go 360 degrees, so that the 3/6 mark ends up where it started. DPMS for some reason builds (or at least did build) their pieces with one minute clicks; so that the wheel only goes about halfway around. Which means that the range markings on the wheel are useless, since they're calibrated for half minute elevation clicks 
|
AR Sponsor