[ARCHIVED THREAD] - Charging Handle Roll Pin?

Posted: 7/3/2010 3:00:15 PM EDT

While attempting to install a Badger Ordinance Tactical Latch I lost the roll pin. Can anyone tell me what size they are? I found a link on another post that had pin and spring sizes, but the charging handle roll pin wasn't listed. Also, can I just get some at the hardware store? or are they some specialty kind I need to get from a gun shop? I used a 1/16" punch it felt a bit tight going in, that is the correct size? Thanks.

Posted: 7/3/2010 3:09:20 PM EDT

[#1]

its a 1/16 roll pin its the same as the gas tube pin.

Posted: 7/3/2010 3:16:58 PM EDT

[#2]

Quoted:
its a 1/16 roll pin its the same as the gas tube pin.

So I can just pick a few up at the hardware store?

Posted: 7/3/2010 3:19:54 PM EDT

[#3]

yes you can get 1/16 roll pins at tsc or Lowe's just cut to size.

FYI... gas tube roll pins are 5/64 not 1/16

Quoted:

Quoted:
its a 1/16 roll pin its the same as the gas tube pin.

So I can just pick a few up at the hardware store?

Posted: 7/3/2010 3:31:58 PM EDT

[#4]

Quoted:
yes you can get 1/16 roll pins at tsc or Lowe's just cut to size.

FYI... gas tube roll pins are 5/64 not 1/16

Quoted:

Quoted:
its a 1/16 roll pin its the same as the gas tube pin.

So I can just pick a few up at the hardware store?

Thanks.

[ARCHIVED THREAD] - Charging Handle Roll Pin?

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Charging Handle Roll Pin?

[ARCHIVED THREAD] - Charging Handle Roll Pin?