Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
AR Sponsor
10/1/2009 11:37:04 AM EDT
I Have a 11.5" barrel and want to bring it to 16"by pin and weld.  Which one of these would bring it to 16"?  I cant find the lenth other than the extnded one and they look to be different lenghts.

Got this from Bushmaster website.

CAR 15 Extended Flash Suppressor
High quality, manufactured in the U.S.A. - the six slot design makes these suppressors very effective on the short barrelled carbine. For threaded barrels only (1/2" x 28 T.p.I.). CAR 15 Extended Flash Suppressor, 5.5" overall -threaded for all Pre-Ban barrels.

Options: Car 15 Extended, Shorty Look Standard, Shorty Look Heavy or Car 15 Originl
10/1/2009 12:09:45 PM EDT
[#1]
Because of the slip over of 3", the 5.5" one only gives you a little over 2" of extended length.  I have one that I threaded on to to measure for you and confirmed it.

I doubt the other ones will do it either unless they measure 5.5 and thread directly on the end without any slip over.  Even that would be very close.
10/1/2009 1:45:17 PM EDT
[#2]
Thanks.  Do you know where I can find one that does not slip over?
10/1/2009 1:47:12 PM EDT
[#3]
Not for sure, but you might ask 45Bravo.  He may have a solution.
10/1/2009 2:17:59 PM EDT
[#4]
45Bravo

He'll set you up.
10/1/2009 7:15:52 PM EDT
[#5]
If you get the Bushmaster one there are 4 options at checkout. You want the CAR 15 extended.  It is 5.5 and not a slip over and will work.  But 45bravo probably has one that looks a lot better.
10/1/2009 9:15:00 PM EDT
[#6]
I had one of those pinned, non-slipover Bushmaster 5.5" flash hiders.  I had to get rid of it because it was so...unauthentic.  Get one from 45Bravo, it will look much better.  This is what mine looked like:

10/2/2009 4:16:52 AM EDT
[#7]
Check out my post Huraahh ,I finally get to post,,,that barrel is a 45bravo masterpiece,,you WILL be thrilled with his work.
AR Sponsor