AR Sponsor
Posted: 2/18/2013 5:06:06 PM EDT
| Hey guys, Just installed a new PWS Triad on my AR and after about 60 rounds it went for a trip down range. It has to be timed and included peel washers for installation. I got it to where it was about 30 degrees from the timed position after hand tightening then finishing with the wrench as per the instructions. Is there a specific torque that it needs to be at? Should I just do it again but add one more washer and crank the shit out of it? Also its a new barrel and there was a lot of oil on it from packaging should I make sure there is no oil left in the threads? |
AR Sponsor