[ARCHIVED THREAD] - FSB Help

Posted: 7/19/2006 12:19:57 PM EDT

i just got an LMT upper 16" w/ standard FSB. I want to eventually put a mini gas block on and put a full lenght rail over it. How do I put a mini block on when it has the slots for the FSB pins? Most mini blocks screw on right?

Posted: 7/19/2006 1:38:18 PM EDT

[#1]

Depending on the rail, you could just cut the orig. FSB to fit inside of it.

Posted: 7/19/2006 3:12:49 PM EDT

[#2]

Quoted:
Depending on the rail, you could just cut the orig. FSB to fit inside of it.

I would just knock the pins off the FSB and install a mini block and keep the original FSB intact that way you won't have to have a new FSB redrilled to fit the old pin channels.

Just my take on it.

Edit : How do I put a mini block on when it has the slots for the FSB pins?

You just clamp the mini block over it and leave the fsb pin channels there.

Posted: 7/19/2006 7:01:13 PM EDT

[#3]

If I knock of the pins and put a mini in they wont have the same pin set-up will they? Most I have seen have 2 screws that screw up from the bottom as opposed to being inserted like the FSB originals. EDUCATE ME!

Posted: 7/19/2006 7:29:52 PM EDT

[#4]

Quoted:
If I knock of the pins and put a mini in they wont have the same pin set-up will they? Most I have seen have 2 screws that screw up from the bottom as opposed to being inserted like the FSB originals. EDUCATE ME!

You got a pic of the new FSB you have in mind...?

Posted: 7/19/2006 7:31:35 PM EDT

[#5]

PRI low profile gas block screws in from the bottom. You don't need to worry about aligning anything.

Also, check out MIs new low profile gas block. I just got a sample but it's plenty low and it will be $40 - $45.

John

[ARCHIVED THREAD] - FSB Help

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - FSB Help

[ARCHIVED THREAD] - FSB Help