AR Sponsor
Posted: 8/10/2013 2:07:38 PM EDT
|
Need some input here..
Is it necessary to use crush washer or shim when I mount the FSC30? Reason I ask is when I use crush washer, logo faces between 2-3 clock position and its impossible to crush the washer to get the logo facing 12:00 clock.. Now, if I don't use crush washer, logo face between 11-11:30 and I think I can turn the FSC30 enough to face logo to 12:00 I could buy shim pack, but do I need to. Beside shipping cost more than shim pack 
Thanks in advance. |
|
With my FSC556 I had to back it off and turn it down four times maybe more before it lined up with a crush washer. Just cranking on it will not work.
From the reading I have done since it seems that shims would likely be a better/easier route, and just about the only one if you already tried the above. |
|
Quoted:
Need some input here.. Is it necessary to use crush washer or shim when I mount the FSC30? Reason I ask is when I use crush washer, logo faces between 2-3 clock position and its impossible to crush the washer to get the logo facing 12:00 clock.. Now, if I don't use crush washer, logo face between 11-11:30 and I think I can turn the FSC30 enough to face logo to 12:00 I could buy shim pack, but do I need to. Beside shipping cost more than shim pack
Thanks in advance. Crush washer should allow approximately 400 degrees of rotation (more than one full turn) from first contact: how can that not be sufficient? 
mully |
AR Sponsor