[ARCHIVED THREAD] - Fab 10 lower modification

Posted: 10/18/2007 3:21:27 PM EDT

I posted this over in the california hometown forum but only got a few replys. Question is...The fab 10 lower has a sealed magazine well and the magazine is fixed with a set-screw and a rivet. What i want to do is drill out the rivet and have the set-screw be the means of keeping it a fixed magazine (in order to satisfy california law). I would still have to crack the gun in half to load and use a tool(allen wrench) to remove the magazine. What i'm trying to achieve is a way to pre-load an extra magazine so i dont have to carry loose ammo. It would also make unloading much easier. Does anyone familiar with the california assualt wepons law see any problem with this modification? Thanks

Posted: 10/18/2007 7:24:41 PM EDT

[#1]

Having a magazine is fixed is perfectly legal. Turning the set screw to drop the mag is not. If you want to legally drop the mag get a bullet button at tenpercentfirearms.com or coldwarshooters.net

Posted: 10/21/2007 7:01:19 AM EDT

[#2]

So what would be the difference of using a allen wrench (tool) to loosen the set screw to drop the mag vs a bullet (tool) to drop the mag on the bullet button?

Posted: 10/21/2007 7:50:53 AM EDT

[#3]

repeatedly turning a steel screw in and out of an aluminum receiver won't give you the service life you would like.

advntrjnky

[ARCHIVED THREAD] - Fab 10 lower modification

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Fab 10 lower modification

[ARCHIVED THREAD] - Fab 10 lower modification