AR Sponsor
Posted: 1/23/2010 8:04:48 PM EDT
|
first time i've installed a non milspec trigger. this build went super easy except for the timney trigger install, no scratches, i rememberd to clean n coat everything in CLP this time.
the timney was easy to install up to the last part, putting the second pair of set screws in to lock in the bottom set screws. this is a pain in the ass! one side went easy, i pryed the spring away n screwed it right in and tight. the other side was a bitch! i think the threads where messed up but it was extremely hard to get started, and once i did i had to use a pair of pliers to turn the allen wrench half a turn at a time to tighten it all way down. but after that smooth sailin. 
|
|
Quoted:
Good job! What are the plans for the upper? thanks! parts i have: BCM upper receiver BCM standard 16 inch , mid length BCM BCG Parts in transit: CTR FDE Stock MIAD FDE Grip BCM Gunfighter Charging Handle what i need: DD 12inch Lite Rail DD Low pro gas block or Vltor gas block gas tube FSC556 compensator Troy BUIS Larue Mount for ML2 FUG vert grip ST-T2 Buffer and Spring |
AR Sponsor