Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
8866 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
fightlite
DFC
silencerShop
midwest
Holosun
JRH
Guns
springfield
palmetto
magpul
primaryArms
geissele
aim
bravocompany
cz
GS
brownells
vortex
colt
RS
skd
8866 Online
primaryArms
DFC
silencerShop
springfield
colt
JRH
vortex
palmetto
magpul
Guns
RS
aim
midwest
GS
brownells
fightlite
cz
bravocompany
geissele
Holosun
skd
AR Sponsor
Sponsor News Introducing TNVC's NEW and Exclusive Filmed SuperGain (FSG) and Chimera Panoramic Goggle Giveaway!
Site News The People of Virginia VS Grabigial BanBerger | ARFCOM News
11/18/2012 5:20:05 AM EDT
I'm getting ready to install my barrel using an outer reciever nut and an inner barrel retainer nut. I realize that I need to maintain gas tube alignment of the outer nut while achieving proper torque of the inner nut. I  have a steel gas tube size rod that I can stick in from the back end that holds the outer nut in alignment. Is this OK, or, any ideas that are better ways to do this? I do not want to use LocTite.
11/18/2012 5:28:59 AM EDT
[#1]
The Seekins SARv2 Rail is similar. You just have to allow for the extra degrees in the clockwise rotation of the pieces to align everything up.

Not really that hard, just a couple of trys to get everything matched up.
AR Sponsor
geissele
ar15com
SAS
fightlite
CA
springfield
brownells
bravocompany
Pro2A
cmmg
LAPG
ar15com
blackhills
colt
THBRD
Faxxon
RS
LAPG
gray
silencerShop
primaryArms
ar15com