I was putting some new furniture on a lower last night instead of going to bed at a decent hour.
Anyway, I notice the new grip has a gap on top of it. I can see the spring.
Should I just ignore it or try to fit it to the lower?
Posted: 2/23/2011 8:37:36 AM EDT
[#1]
I've seen this before. Sometimes there's always a little gap, sometimes not.
I would check your screw length, try a shorter screw. Also run your screw in and out a few times to make sure it's seating all the way.
Posted: 2/23/2011 8:46:49 AM EDT
[#2]
Pull the grip and check in the well that goes around the lower and see if there's any debris in it.
Posted: 2/23/2011 9:01:01 AM EDT
[#3]
Just had that happen on a new build. I took a rubber mallet and gently tapped until it mated up tight. I think in my case, it was just tolerance limits..
Posted: 2/23/2011 3:58:02 PM EDT
[#4]
It happened to me once - had the wrong spring for the selector in it.
