[ARCHIVED THREAD] - Hammer locking back with trigger depressed

Posted: 9/9/2006 8:21:11 AM EDT

I'm building my lower right now and just wanted to check something out. I just installed the trigger assembly and hammer. I did the function check. The hammer releases fine.

I'm holding the trigger back after releasing the hammer and then pulling the hammer back again to check that it locks back. It does, but with more force than it took to cock it. Also, when it catches on the disconnector, it's moving the trigger slightly as it goes over the "hump".

1. Am I describing this correctly?
2. Is this normal?

It seems right, but I just thought I'd double check. Thanks.

Posted: 9/9/2006 8:23:22 AM EDT

[#1]

Just did what you described on my lower and it took the same force with the trigger back as it did with it not back and it did NOT move the trigger when engaging the disconnector.

Not sure if thats an issue for you or not. But those were my results.

Posted: 9/9/2006 8:43:21 AM EDT

[#2]

Ah, I got it. After inserting the selector, it now performs as described. Same effor, no movement of the trigger. Thank you.

Posted: 9/9/2006 8:51:13 AM EDT

[#3]

Glad to have helped.

[ARCHIVED THREAD] - Hammer locking back with trigger depressed

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Hammer locking back with trigger depressed

[ARCHIVED THREAD] - Hammer locking back with trigger depressed