[ARCHIVED THREAD] - Handguard Removal Tool?

Posted: 3/19/2006 3:06:26 PM EDT

Do you serious AR builders use the tool that ADCO and Brownells sells? It's been about 20 years but I don't recall the handguards on M16 A1 being that difficult to remove with just bare hands. It was the old style that was flat on the bottom; maybe the newer round ones require tools???

Posted: 3/19/2006 3:20:19 PM EDT

[#1]

The new springs are hard as heck to remove if you are an older fart like me, do not waste your money on the ones made out of wire since they are a POS.

Posted: 3/19/2006 3:27:23 PM EDT

[#2]

Do you use the tool to install the handguards, or just to remove them?

Posted: 3/19/2006 3:33:04 PM EDT

[#3]

The tool can be used either to remove or install. I bought one because I had a Surefire M500 and it's designed to be extra tight. Once I got it on there I couldn't get it off, even with help, until I got a tool. With regular handguards I don't think I've ever used it.

Posted: 3/19/2006 3:36:43 PM EDT

[#4]

Both ways for me, I am fitting a set of hand guards on a Bushmaster 308 that was made for an AR15, have to use the tool since these are very tight and I am WESCOG fitting them.

If it were not for the hand guard tool I would have been like Gus.

Posted: 3/19/2006 6:13:32 PM EDT

[#5]

I use the Bushmaster tool, it makes the handguard removal and install a simple one-person job. Life is short, why not?

[ARCHIVED THREAD] - Handguard Removal Tool?

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Handguard Removal Tool?

[ARCHIVED THREAD] - Handguard Removal Tool?