AR Sponsor
Posted: 12/8/2003 12:58:12 AM EDT
|
I cant get the Roll pin out of the Bolt that holds in the ejector. Do i have to depress ejector then try to drive out the small roll pin? Or am i not doing something right? Thanks- s-3 |
|
You should be able to tap out the roll pin with a 1/16" punch and hammer... after the roll pin is out the spring and ejector will pop out as you withdraw the punch. You may need to use a vise To reinstall, confirm the groove on the ejector is rotated so the roll pin can be installed, compress the spring/ejector with a 3/8" punch while installing the roll pin... almost a 3 handed job without a vise... |
| I see no reason to have to depress the ejector while removing the roll pin, I have never needed to. When the roll pin pops out, the punch will be holding the ejector back. So you don't have to worry about the ejector zinging out upon removal. Just be sure to catch it when you remove the punch. However, the ejector WILL need to be held in when you go to reinstall the roll pin. |
AR Sponsor