AR Sponsor
Posted: 11/16/2008 7:54:41 PM EDT
| My rear sight knob has 6 clicks between the "6/3" and "4" setting. If I understand the "Improved Battle Sight" instructions, I need to loosen the screw, rotate the sight 4 clicks clockwise, tighten the screw, and then when I turn the knob counterclockwise, it should bottom out at 4 clicks below the 6/3 setting. Then I leave the sight at 4 clicks below 6/3, zero at 50 yards by adjusting the front sight post, and leave the rear sight at 4 clicks below 6/3 for all distances short of 200 meters. Is this correct? |
| Ok, I did it, I'm now wondering, would it be the same thing if I adjusted the knob five clicks clockwise, tightened screw, but still only turn the knob down 4 clicks past 6/3? Then the knob won't have to be completely bottomed out (5 clicks below 6/3 will bottom out, 4 clicks below 6/3 for 200m setting), or would this change the sight configuration? |
|
Quoted:
Quoted:
Is that knob two seperate pieces? Yes it is two separate pieces, the 6/3 part is the one that will move. Wait a minute, I thought that after you loosen the screw, the 6/3 part of the knob should remain in place and the bottom part should move? Now I'm confused. |
|
Quoted:
Quoted:
Quoted:
Is that knob two seperate pieces? Yes it is two separate pieces, the 6/3 part is the one that will move. Wait a minute, I thought that after you loosen the screw, the 6/3 part of the knob should remain in place and the bottom part should move? Now I'm confused. No I was the one that was confused. Sorry it's been a bit since the last one I did, you are correct. |
AR Sponsor