[ARCHIVED THREAD] - Installation of Magpul trigger guard???? help

Posted: 3/15/2005 4:51:12 PM EDT

I just my magpul trigger guard and it came with a roll pin and a hex threaded screw. I understand that the Magpul is made not fold down. Any suggestions on installation of the threaded screw? Should I use locktite or other method to install this part? Any help would be appreciated.

Posted: 3/15/2005 5:05:23 PM EDT

[#1]

Installed mine without loctite. It holds just fine. Although I am sure loctite wouldnt hurt.

Posted: 3/15/2005 5:56:03 PM EDT

[#2]

I didn't put loctite on mine. If I ever see it coming out I will apply some loctite, but I doubt that will ever happen.

Posted: 3/15/2005 5:56:40 PM EDT

[#3]

I own a Buell motorcycle. If a fastener does not have loctite on it, it has anti-seize compound. You have to use one or the other on almost every fastener... habits are hard to break.

So... I put loctite on the screw, since I was not concerned if the screw threads seized!

Posted: 3/15/2005 8:32:35 PM EDT

[#4]

I asked the guys at Tactical Solution this question, and they said Loctite isn't needed, just tighten it.

[ARCHIVED THREAD] - Installation of Magpul trigger guard???? help

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Installation of Magpul trigger guard???? help

[ARCHIVED THREAD] - Installation of Magpul trigger guard???? help