AR Sponsor
Posted: 7/3/2011 12:27:36 PM EDT
| Where is a good place to get an AR15 stripped lower with the large pin holes? I can't seem to find them anywhere. I dont know if it would be worth it to get one with the large pin holes or with the small holes and have a smith drill them out? |
|
Quoted:
WHY???????  ....you have a large pin upper......reducer bushing should allow you to use it with a small pin lowerI have a Colt trigger, hammer and disconnect from a Colt AR15 that I had swapped the trigger on. I sold the Ar15 but still have the trigger set. I sent it to Bill Springfield for a trigger job and now I am looking for a lower receiver to put it in. The Colt pins are .170" as opposed to the commercial pins that are .154" |
I kept thinking takedown pin holes|
have you considered selling the .170 fcg, and replacing it with the .154?
doesn't cost anything to try on the EE. a .170 Colt fcg fron colt's way higher than .154's from aftermarket vendors. i don't have a problem with the .170 per se., but i'd keep all my rifle parts common if i could. |
AR Sponsor