AR Sponsor
Posted: 2/12/2014 1:23:30 PM EDT
|
So I installed my POF EFP trigger assembly, and when I went to install the safety (BAD-ASS) I found that there is just a bit of the trigger assembly hanging up in the way. Any solutions to this problem would be appreciated. Thanks.
http://i1328.photobucket.com/albums/w527/dustinbrundrett/20140212_170922_zpserif6ltc.jpg |
|
Quoted:
Try installing with the safety in place and set to FIRE. Quoted:
Try installing with the safety in place and set to FIRE. Tried this already with no luck, but thanks. Quoted:
Install with just the hammer pin. Then add safety, put selector to fire, then put in trigger pin. Thanks, I'll give this a shot and report back. |
|
Gave it a shot this morning and it worked perfectly. Thanks a lot for the help.
http://i1328.photobucket.com/albums/w527/dustinbrundrett/20140213_055436_zpsqw7t0ruy.jpg http://i1328.photobucket.com/albums/w527/dustinbrundrett/20140213_055541_zpsuukevenu.jpg |
|
Cool upper... is that the CMT upper?... and I like dust cover.. thats the v7 cover right?
Did you have to modify it at all to get it to fit? |
|
Quoted:
Cool upper... is that the CMT upper?... and I like dust cover.. thats the v7 cover right? Did you have to modify it at all to get it to fit? Yeah, the upper and lower are both CMT Tactical. Yeah, the dust cover is the v7. The fit is fine. Went on with no issues (minus the extremely tight tolerances for the pin holes.) |
AR Sponsor