[ARCHIVED THREAD] - Never mind... Fixed it

Posted: 9/19/2008 5:34:54 PM EDT

Ok, got a Del-ton middie, with the PRI gas block installed. Ordered the Daniel Defense Lite rail 12.0. How the hell do I get the gas block tightened back in place once I get the rail in place? I checked the tutorial tacked above, but no one shows exactly how to do it, and I am about ready to chunk this damn thing out the back door!!!!!!!!!!!!

A little help from the hive minds would help my sanity right about now!

ETA>>>> Fixed the problem... i am a dumbass.

Posted: 9/19/2008 6:35:51 PM EDT

[#1]

You need a low profile gas block, so that you can slide the rail over top of it.

Posted: 9/19/2008 7:07:05 PM EDT

[#2]

Got the PRI low profile on it. I just can't get the allen wrench inside the rail to tighten the dadburn allen nuts on the PRI. How do you get this thing tightened down?

Posted: 9/19/2008 7:12:10 PM EDT

[#3]

Would it be possible to not fully secure the rail, rotate is slightly so you can slip the allen wrench through a hole in the rail, tighten the gas block, then tighten up the rail?

Posted: 9/19/2008 7:14:22 PM EDT

[#4]

Don't know on the DD rail but on the LaRue you install the nut for the rail, then the gas block and tighten it, then slide the rail over the gas block and tighten the rail.

Posted: 9/19/2008 7:16:36 PM EDT

[#5]

I figured it out. i did not get instructions with it, as I bought it used from another site. I feel like an idiot now. Thanks anyways guys!

Posted: 9/19/2008 7:17:54 PM EDT

[#6]

Quoted:
I figured it out. i did not get instructions with it, as I bought it used from another site. I feel like an idiot now. Thanks anyways guys!

Hey at least you got it to work.

[ARCHIVED THREAD] - Never mind... Fixed it

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Never mind... Fixed it

[ARCHIVED THREAD] - Never mind... Fixed it