[ARCHIVED THREAD] - No Windage Left

Posted: 4/8/2005 12:36:12 PM EDT

For my BUIS I have a PRI flip up front with an YHM flip up rear. After sighting it in the YHM rear has only a few clicks of left windage remaining. Is there anyway to modify the sights so that the rear aperture is more centered, giving more clicks to the left?

Posted: 4/8/2005 2:39:29 PM EDT

[#1]

Quoted:
For my BUIS I have a PRI flip up front with an YHM flip up rear. After sighting it in the YHM rear has only a few clicks of left windage remaining. Is there anyway to modify the sights so that the rear aperture is more centered, giving more clicks to the left?

Yes adjust your PRI front sight so its centered.

Posted: 4/9/2005 2:55:42 PM EDT

[#2]

Thanks for replying. I had thought of that but it's a gas block sight. I can't move it without disrupting the gas flow.

Posted: 4/9/2005 3:25:00 PM EDT

[#3]

there is more than enough room for you to adjust the front gas block.

the hole on the pri is much bigger than the hole in the barrel so you have that to play with.

i have the pri front flip too along with the troy rear and at first it was also canted. just had to loosen the front and slightly move in the direction needed.

this is if you have the clamp on front sight base, i dont know how much you could adjust with the crosspin pri

Posted: 4/10/2005 6:11:25 AM EDT

[#4]

My PRI is the clamp version so I have some wiggle room.

Thanks for the advice, I'll give it a try.

Posted: 4/27/2005 6:08:22 PM EDT

[#5]

I was able to adjust the front sight as Boom and Eklikwhoa suggested. Rear sight is now centered and the rifle is getting enough gas so it's not short stroking.

[ARCHIVED THREAD] - No Windage Left

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - No Windage Left

[ARCHIVED THREAD] - No Windage Left