[ARCHIVED THREAD] - Pmag over insertion?

Posted: 10/9/2012 9:48:30 PM EDT

What was this problem? I tried looking it up, but didn't find much except it existed. One site mentioned the SCAR, so was it just non AR type weapons?
Pmags are getting cheaper due to the M3, so I may pick up a couple dozen if there is no problem in Ars.

Posted: 10/10/2012 6:44:40 AM EDT

[#1]

I have that problem with a few 20's I have. If I insert them hard they will override the mag release & get stuck. None of my 30's however had this happen.

Posted: 10/10/2012 7:10:50 AM EDT

[#2]

Had a course once where one of the students got frustrated during a malfunction and rammed the Pmag home.

30 round Pmag into a AR (I think it was a S&W).

Took a little bit but we finally got it out of there.

Posted: 10/10/2012 2:47:42 PM EDT

[#3]

Quoted:
What was this problem? I tried looking it up, but didn't find much except it existed. One site mentioned the SCAR, so was it just non AR type weapons?
Pmags are getting cheaper due to the M3, so I may pick up a couple dozen if there is no problem in Ars.

Current PMags have an over insertion stop in the front edge of the magazine where it meets the magazine well on an M4.

Now that the PMag M3 is compatible with longer HK416 mag well, the over insertion stop is at the rear of the magazine.

[ARCHIVED THREAD] - Pmag over insertion?

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Pmag over insertion?

[ARCHIVED THREAD] - Pmag over insertion?