AR Sponsor
Posted: 11/30/2011 7:20:37 AM EDT
| I have a YHM lo-prp gas block. It has the cup/bracket against it that holds the front of the HG in place. I'm about to install a RA'S EVO FF HG & I need to get this bracket off but I don't think I can get the ITS Forked flash hider off w/out also loosening the barrel w/out special tools. So can I loosen gas block, slide forward & then use some good tin snips, dremel or something & cut this bracket off? Thanks. |
| neither end is hard to do. I've done a handful of delta rings with a dremel. go slow and watch to make sure you arent getting the barrel nut. It is a bit messy. My hg cap was loose and I couldnt drive the pins out of the fsb so I cut it with the tin snips at about 12, 4 and 8. It came off easily. |
AR Sponsor