Building an AR pistol. Installed ATI pistol buffer tube. Is there any "requirement" that the Shockwave be fully forward before tightening down the screw? I would prefer it out a few inches.
Posted: 9/29/2016 8:12:22 PM EDT
[#1]
You can adjust it anywhere you want. Not so sure it will fit ideally on the brace you purchased though. The one I have made specifically for the Shockwave has a larger outer diameter. KAK makes a buffer tube specifically for the Shockwave brace.
Posted: 9/29/2016 8:16:00 PM EDT
[#2]
Nope, put it where you want it. The KAK buffer tube has demples for placing it at different locations. That's the best tube to use with the blade.
Posted: 9/30/2016 12:55:17 AM EDT
[#3]
If you don't have it set to a fully inward position, I will report you to the authorities.
Posted: 9/30/2016 2:02:18 AM EDT
[#4]
Quote History
Quoted: If you don't have it set to a fully inward position, I will report you to the authorities.
View Quote
Lol.
Posted: 9/30/2016 9:51:19 AM EDT
[#5]
You can mount it anywhere you want I have two of the KAK tubes, they work very well with dimples in 12 spots, but I also have an older PSA tube that works perfect as well, but no dimple, just tighten the set screw down, it will make it's own dimple.
Posted: 10/2/2016 9:01:12 AM EDT
[#6]
I just put one on a 8.5" 300. Really like it. Dimples on the KAK tube are nice. Od green matches the moe grip which is nice.
