Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
7509 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
silencerShop
GS
brownells
midwest
aim
RS
Guns
colt
geissele
OSIGHT
palmetto
DFC
vortex
JRH
primaryArms
bravocompany
fightlite
Holosun
skd
springfield
cz
magpul
7509 Online
colt
geissele
Holosun
primaryArms
vortex
fightlite
silencerShop
OSIGHT
palmetto
RS
magpul
skd
DFC
bravocompany
midwest
aim
JRH
Guns
GS
springfield
brownells
cz
AR Sponsor
Site News Could You Have Stopped This? Vegas Shooting Analysis with Attorneys on Retainer
9/3/2007 6:38:37 AM EDT
Guys...was thumbing through Sweeney's book on the AR-15 the other day at a bookstore. One of the pages had a sight installation jig that mechanically lined up the front sight with the rear carry handle/sight. Looked like some square maybe aluminum stock or something that allowed the gunsmith/assembler to square everything up. None of the usual gunsmithing tool vendors seem to have it.

Any suggestions???
9/3/2007 7:30:52 AM EDT
[#1]
Use drill rod turned to fit within the slot on the carry handle, one end flat and the other turned to a point. You'll need a different one for each length of gas system. Check them periodicaly on a surface block for true.
AR Sponsor
blackhills
cmmg
geissele
primaryArms
ar15com
ar15com
THBRD
LAPG
bravocompany
colt
palmetto
Faxxon
silencerShop
RS
SAS
fightlite
CA
ar15com
brownells
Pro2A
gray
LAPG