Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
AR Sponsor
3/28/2005 3:48:13 PM EDT
I've just started down the road of building my first AR, and I want to build it into a CMP service match rifle. However I also would like another A2 type rifle for plinking and informal shooting too, so I figure I'll get both a match upper and a standard 20" upper and swap them onto my lower as needed.

Is this a bad idea? If not too bad as long as not done often, how much would be a bad thing?

Eventually I'm planning on adding building/getting another complete lower for the "standard" rifle, but in the beginning it would be easier on the pocketbook to go with the two uppers, one lower solution.

Thanks,
Dave
3/28/2005 4:42:43 PM EDT
[#1]
JustDave
     That is the most realistic idea I have heard in a long time!  Good luck on the project and     enjoy!

P.S. don't forget to go with bolt assemblies for each upper rather than swapping them back and forth.

Scorpion34 OUT!
3/28/2005 5:17:10 PM EDT
[#2]
Swap out the uppers to your heart's desire.

Like Scorpion34 said above, just use complete uppers that have their own dedicated bolt carrier assemblies.

3/28/2005 5:20:16 PM EDT
[#3]

Quoted:
Swap out the uppers to your heart's desire.

Like Scorpion34 said above, just use complete uppers that have their own dedicated bolt carrier assemblies.



+1



but remember........2 uppers almost always turns into a good excuse to get another lower!
3/28/2005 5:21:12 PM EDT
[#4]
Why, what's this about the bolts?  Why do they have to be dedicated?  I'm learning, not flaming.  
3/28/2005 5:41:02 PM EDT
[#5]

Quoted:
Why, what's this about the bolts?  Why do they have to be dedicated?  I'm learning, not flaming.  



That's how I did it with only one pre-'94 lower.  It had about four or five uppers for it with bayonet lugs and FHs.

Keeping a bolt with a barrel is a good idea, but you could probably get away with swapping them.
3/28/2005 6:50:20 PM EDT
[#6]
When a gun is broken in and/or natural use puts wear on the gun, each individual barrel leaves its own unique wear patterns on the bolt/chamber. These barrel "fingerprints" are not a bad thing. A new bolt that was broken in with a new barrel will actually operate together more smoothly and accurately if that same setup is kept, as the two systems will be tuned to each other. Imagine it as wearing the same pair of leather gloves everyday for years. Then someone else goes to put them on. They fit, but they dont have the same feel as they do for you. The same is the case here.  Since you are building a marksmanship rifle, and accuracy is key, the small reduction in accuracy would be something to be avoided. Each barrel needs its own chamber/bolt assembly.

As long as you're sure to do this, switching out COMPLETE uppers is no problem.

-G
AR Sponsor
Close Join Our Mail List to Stay Up To Date! Win a FREE Membership!

Sign up for the ARFCOM weekly newsletter and be entered to win a free ARFCOM membership. One new winner* is announced every week!

You will receive an email every Friday morning featuring the latest chatter from the hottest topics, breaking news surrounding legislation, as well as exclusive deals only available to ARFCOM email subscribers.


By signing up you agree to our User Agreement. *Must have a registered ARFCOM account to win.